Undergraduate Theses
Permanent URI for this collectionhttps://hdl.handle.net/20.500.14583/13
Browse
6 results
Search Results
Item Determination of instrument detection limit and method detection limit of Varian 55B flame atomic absorption spectrometer for cadmium, chromium, copper, iron, lead, manganese and zinc using sips-10 and manual sample introduction methodsCalawigan, Roland Joseph C. (Department of Chemistry, College of Arts and Sciences, University of the Philippines Visayas, 2009-04)Determination of detection limits is an essential measure of performance for a quantitative laboratory, method or analyst. In this study, the Instrument Detection Limit (IDL) and Method Detection Limit (MDL) of F-AAS Varian 55B for cadmium, chromium, copper, iron, lead, manganese and zinc were determined using the SIPS-10 and manual sample introduction methods. For IDL determinations, EPA’s SW-846 method (Test Methods for Evaluating Solid Waste and Physical/Chemical Methods) was employed for both sample introduction methods where deionized water was analyzed for twenty times for three non-consecutive days. MDL determinations were done based on the definition given by the United States Code of Federal Regulations (40 CFR part 136, Appendix B - Definition and Procedure for the Determination of the Method Detection Limit). In this procedure, MDLs were estimated by calculating the standard deviation from the analysis of a standard solution containing the analyte with a concentration determined from the estimated detection limit, which was also analyzed for twenty times. Results showed that for the determination of IDL, all of the elements have lower values (Cd 0.000887 mg/L, Cr 0.00435 mg/L, Cu 0.000128 mg/L, Fe 0.000816 mg/L, Pb 0.000742 mg/L, Mn 0.000985 mg/L, Zn 0.000585 mg/L) for the manual method than the SIPS-10 method (Cd 0.00399 mg/L, Cr 0.0150 mg/L, Cu 0.00222 mg/L, Fe 0.00913 mg/L, Pb 0.0217 mg/L, Mn 0.00132 mg/L, Zn 0.00445 mg/L). For MDL, the results showed variations for both the two sample introduction methods. The MDL values for cadmium, chromium, copper, iron, lead, manganese and zinc are 0.0374 mg/L, 0.0235 mg/L, 0.00203 mg/L, 0.0197 mg/L, 0.0805 mg/L, 0.00325 mg/L and 0.00686 mg/L in the manual method, respectively and 0.0101 mg/L, 0.0429 mg/L, 0.00280 mg/L, 0.0186 mg/L, 0.19 7 mg/L, 0.00312 mg/L and 0.0103 mg/L in the SIPS-10 method, respectively. Both methods have comparable precision for copper, iron, manganese and zinc determinations while SIPS-10 method is more precise for cadmium, chromium, and lead analysis.Item Heavy metals (Cr, Cu, Pb, and Zn) concentrations of road-deposited sediments within six public plazas in Iloilo CityCaceres, Rizza Daphet E. (Department of Chemistry, College of Arts and Sciences, University of the Philippines Visayas, 2011-04)Contamination from overland transportation is an unavoidable result of urbanization. Cr, Cu, Pb, and Zn arc common heavy metals introduced to the environment by transportation. Road-deposited sediment (RDS) samples were collected from six public plazas (Villa Plaza, Molo Plaza, Mandurriao Plaza, Plaza Libertad, Lapaz Plaza and Jaro Plaza) in Iloilo City from March 2010 to May 2010. 0.5M HC1 was used as extractant and heavy metals (Cr, Cu, Pb, and Zn) concentrations were determined using Flame Atomic Absorption Spectrophotometer (FAAS). The mean concentrations of Cr, Cu, Pb, and Zn in road-deposited sediments from six plazas were 8.79 ± 1.93, 40.90 ± 24.21, 60.74 ± 22.32, and 164.25 ± 25.0 mg/kg, respectively. Metal enrichment of Cr, Cu, Pb and Zn were approximately xl, x8, x7 and x18 more than the background values respectively. There was no significant temporal variation in metals concentrations of RDS between sampling collections. Generally, RDS from Plaza Libertad has the highest metal concentrations. Cu and Pb metals were highly correlated (R2 = 0.891) indicating possible similar sources. A good correlation (R2 = 0.918) was observed between Pb concentration and the number of vehicles that pass along the plaza per hour. Heavy metal concentrations in sediments from plazas have low hazard quotients but bioaccumulation of metals in the body could cause health effects. Efficiency of digestion procedures varied depending on characteristics, texture and composition of road-deposited sediments. 0.5M HC1 digestion was used because it is simple, cost-effective, time-efficient and it leaches out meaningful amounts of bioavailable metals. Using HC1 as extractant simulates human digestion since human stomach contains HC1 that could leach out metals if road-deposited sediments were ingested.Item Determination of heavy metal (Cu, Cd, and Pb) concentration in musclemeat of fish from different areas in Batan Bay, AklanBagarinao, Cathrina F. (Department of Chemistry, College of Arts and Sciences, University of the Philippines Visayas, 2014-04)Food safety is of utmost importance but it is usually compromised by the presence of pollutants in the environment such as heavy metals. This study was conducted to investigate heavy metals concentrations in fish musclemeat collected from different areas of Batan Bay, Aklan. A total of 22 fish species were analyzed for Cu, Cd and Pb using Flame Atomic Absorbance Spectroscopy. Pb concentration in the musclemeat of fish ranged from 0.0292 ± 0.2070- 2.09 ±1.15 mg/kg wet weight and was found to be highest in Mugil cephalus (flathead grey mullet), while Cd concentration ranged from 0.0075 ± 0.0016-0.157 ± 0.209 mg/kg wet weight with highest value in Megalops cyprinoides (Indo-pacific tarpon), and Cu concentration ranged from 0.0605 ± 0.0667-2.76 ± 0.05 mg/kg wet weight, with highest concentration in Leiognathus equulus (common ponyfish). Among the metals, only Pb concentration in flathead grey mullet exceeded the maximum permissible concentration in food as indicated by the Joint FAO/WHO Codex Alimentarius (1984). Assessment of Noncarcinogenic Hazard Quotient (NHQ) gave NHQ values less than 1, indicating that the risk of developing adverse effects due to fish intake is low.Item Heavy metal concentrations in sediments from Batan Bay and its tributariesAndrada, Mary Royce D. (Department of Chemistry, College of Arts and Sciences, University of the Philippines Visayas, 2014-04)The concentration of three heavy metals (Cd, Pb, Cu) in sediments from Batan Bay and its tributaries were determined in order to assess the degree of contamination of sediments in the said area. The samples were digested following the Method 3050B of US Environmental Protection Program (EPA, 1996). The heavy metal concentrations were determined using Flame Atomic Absorption Spectrometer (FAAS). Results show that the heavy metal concentrations ranged from n.d. - 2.57 mg/kg dry weight (dw) for Cd; 16.44-143.02 mg/kg dw for Cu; and 3.18-28.53 mg/kg dw for Pb. Sediment sample collected from BTN #10 has the highest Cd concentration while sediment sample collected from BTN 052 which is a rice field in Batan, Aklan registered the highest Pb and Cu concentrations. Three sediment quality guidelines (National Oceanic and Atmospheric Administration, Canadian Sediment Quality Guideline and Hong Kong Sediment Quality Guideline) were employed to assess the metal contamination in sediments. The concentrations of Cd and Pb in all sites did not exceed the maximum permissible limits set by the three guidelines. As for Cu, BTN 052 exceeded the Upper Chemical Exceedance Level set by Hong Kong SQG. Correlation analysis showed that there is a significant correlation (p <0.01) between Pb and Cu indicating possible similar source input. Special attention must be given to BTN 052 since the levels of the studied heavy metals are high in this area. The results can be used as basis for the pollution level of sediments from Batan Bay and its tributaries. Special consideration should be given to BTN 052 since all of the test metals are significantly high in this area. It is also suggested to in identify the primary sources of metal contamination in this area.Item Efficiency of constructed filters in removing heavy metals (Cd,Cu,Pb and Zn) from chemical wastewaterAlbaladejo, Anthony Salvador B. (Department of Chemistry, College of Arts and Sciences, University of the Philippines Visayas, 2012-04)The presence of heavy metals at elevated concentrations is a major concern due to its toxic effects to aquatic organisms, plants and humans. Untreated wastewaters from chemistry laboratories could be the key source of heavy metal contamination if not properly processed before disposal to the environment. In this study, the efficiency of the constructed filter, made up of plant-based materials, in removing heavy metals (Cd, Cu, Pb and Zn) from chemical wastewater was determined. Characterization of the untreated and treated chemical wastewaters was also performed using different water quality parameters such as temperature, pH, TDS, TSS, COD, heavy metals and toxicity. Results show that the untreated chemical wastewater contains high concentrations of Zn, Cu, Pb and Cd which did not pass the Department of Environment and Natural Resources (DENR) standards and considered harmful when released to the environment. The physico-chemical characteristics, such as TSS and TDS, of the untreated wastewater also did not pass the standards set by DENR except for pH, temperature and COD. The quality of the treated wastewater failed to pass the DENR standards for TSS and TDS thus the constructed filter was not efficient in improving the said physico-chemical characteristics of the wastewater. Rice hull was efficient in removing Zn, Cu and Pb. Bagasse was efficient in removing Pb and saw dust was efficient in removing Cu. The constructed filter was able to significantly reduce the concentrations of heavy metals from 18-L chemical wastewater. The removal efficiency was not significantly different from the 9-L volume treatment. Pb concentration was within the DENR standards after treatment while Zn, Cu and Cd concentrations were above the requirement. The initial concentration of the metal in wastewater greatly affects the removal efficiency of the constructed filter. Furthermore, the constructed filter was able to minimize the toxicity of the chemical wastewater. These findings could be of significance in the design of the treatment facility that could address the problem of heavy metal pollution.Item Geochemical association of Cr, Cu, Ni, and Pb in the sediments of Iloilo River estuaryArban, John Paul B. (Division of Physical Sciences and Mathematics, College of Arts and Sciences, University of the Philippines Visayas, 2005-04)The geochemical association of Cr, Cu, Ni, and Pb in the sediments of Iloilo River Estuary has been studied using a modified Tessier’s sequential extraction procedure. The results obtained show that most of the metals studied are mostly associated in the residual and organic matter fractions of the sediment samples (Cr: 66.26% - 74.36% in the residual,15.43% - 24.08% in the Fe-Mn oxide fraction, 8.14% - 12.71% in organic matter fraction, and 0.000% - 2.996% in the exchangeable/carbonate fraction; Cu: 39.30% - 46.73% in the residual, 12.00% - 52.18% in the organic fraction, 3.227% - 11.41% in the Fe-Mn fraction, and 0.000% - 17.43% in the exchangeable/carbonate fractions; Ni: 42.75% - 57.02% in the organic matter fraction, 24.93% - 39.33% in the residual, 5.814% - 14.15% in the Fe-Mn fraction, and 5.504% - 13.12% exchangeable/carbonate fraction; and Pb in sample AAA-21: 48.02% in the residual, 38.55% in the organic matter fraction, and 7.33% in the Fe-Mn fraction, and 6.078% in the exchangeable/carbonate fraction). The analysis of the total metal concentrations of the sediment samples taken from Iloilo River are found to be above the reported concentration of uncontaminated sediment except for Pb in sediment sample AAA-21 (Chromium: 102.1 ug/g - 150.5 pg/g; Copper: 62.56 pg/g - 111.7 pg/g; Nickel: 53.40 pg/g - 75.44 pg/g; and Lead in sample AAA-21: 22.21 pg/g). The study shows that about 50% of the total metal concentration in the sediment samples are bioavailable to the aquatic organisms.